Dreame X60 Ultra review

The Dreame X60 Ultra sold on the U.S. site is a robot-and-dock package, not the similar-sounding X60 Max Ultra Complete. The U.S. manual identifies its robot as RLX92DE and its base as RCXE0910. The native listing has white SKU 010201AA000996 and black SKU 010201AA000995; they are finish variants of one functional package.

The space-clearing story needs a tape measure

Dreame lists the robot at 3.13 inches tall with its VersaLift DToF navigation sensor retracted and 4.05 inches with the sensor raised. That headline 3.13-inch dimension is unusually low for a robot with a retracting top sensor, but it is not a guarantee that the machine can enter every opening that measures 3.13 inches. Dreame says VersaLift-enabled entry needs at least 3.19 inches and calls for a flat, unobstructed furniture underside. Measure at braces, trim, uneven flooring and rug edges, and leave some margin. The manual also says the sensor is retractable; that is a useful navigation configuration, not proof that every low sofa is passable.

The robot is 13.78 inches wide and deep and weighs 10.36 pounds. The station is much larger than a charger: 15.34 by 16.65 by 19.65 inches (width, depth, height) and 23.37 pounds.

Two different threshold claims

The U.S. product page distinguishes a 4.5-centimeter (1.77-inch) vertical single-layer step from an 8.8-centimeter (3.47-inch) double-layer threshold. The 8.8-centimeter figure is conditional: the top surface of the lower rise must be over 23 centimeters wide. Dreame describes both as in-house lab claims and says actual performance may vary. For matching the claim to your home, measure the step heights and landing rather than treating the larger number as a general threshold rating. It is reasonable to consider the double-layer mode only when your route has the stated geometry; it is not a promise of a successful crossing.

Rotating pads, several carpet choices

This model uses two rotating Omni-Scrub pads with thermal pad material, not a flat drag cloth or a continuously refreshed roller. The manual documents vacuum-only, mop-only, vacuum-and-mop and mop-after-vacuum modes. Dreame lists pad lifting by 10.5 millimeters, extension and automatic pad-mount removal. Its carpet controls include detaching the mops to avoid wetting high-pile carpet, lifting the chassis and pads for low-pile carpet, and carpet avoidance. Those controls are more flexible than leaving wet pads fixed underneath, but no maximum supported pile depth is published. If deep carpet is the deciding use, regard the depth as unknown rather than extrapolate from automatic pad removal.

The model also is not the X60 Max Ultra Complete. Dreame's U.S. FAQ reserves chassis lifting for crossing thick carpets and a retractable pressure chamber for embedded carpet dust to the Max version. The Max has separate floor-cleaner and pet-odor solution compartments; the X60 Ultra has one solution compartment. If thick carpet or separately dosed pet-odor solution is central to your routine, compare the Max's exact package rather than assuming those parts are shared.

Warm mop claims are not the same as dock-wash heat

Dreame advertises 100°C (212°F) hot-water pad washing at the station. Its fine print says temperatures around the washboard's heating system can reach that level after heating at roughly 23°C ambient conditions, based on its lab data; actual temperature may vary. Separately, the page markets 40°C hot-water mopping. The detail behind that claim describes the mop pads at 30–40°C after one minute of cleaning, with 40°C as a peak. It does not provide a measured temperature for the water supplied to the floor, and the manual instructs the owner to fill the clean-water tank with clean water, not hot water. So a 100°C dock-wash requirement is supported as a maker claim; a strict minimum temperature for water delivered during a mop cycle is not established by these sources.

The station saves pad handling, not all upkeep

RCXE0910 automatically transfers dust into a 3.2-liter bag, washes and hot-air dries the pads, refills the robot's water box from removable tanks, and dispenses solution from a single compartment. The clean and used water tanks are listed at 4.2 and 3.0 liters. The “up to 100 days” dust-bag interval is Dreame's calculated capacity claim, not a schedule for every pet-owning or high-debris household. The manual says to empty and clean the used-water tank after each task. It also lists regular attention for the clean-water tank, washboard filter and heating module, brushes, sensors and mop pads. There is no fixed water-supply or drain connection in the standard package; you fill and empty tanks yourself.

Who should consider it

Consider it for low-profile clearance, washable dual pads, removable tanks and threshold claims that fit your measured route. The 2.4 GHz-only Wi-Fi requirement is a practical setup constraint: the manual says 5 GHz is not supported. Dreame's 35,000 Pa suction and 280-object recognition count are manufacturer claims, not independent carpet pickup or obstacle-avoidance results. Its product page also says liquid-detection functions are still in an over-the-air-update phase; do not buy on the assumption that every advertised liquid feature is already available.

Compare the L60 Pro Ultra if its 3.50-inch sensor-retracted height, removable-tank base and 8.8-centimeter conditional double-layer claim suit you; the X60 Ultra is shorter by listed robot height, but still needs at least 3.19 inches for VersaLift-enabled entry. Consider the D20 Pro Plus if you prefer a simpler, owner-handled flat-pad system over dock-washed rotating pads. Whichever option you shortlist, verify the exact robot and base numbers, check that your network and floor transitions fit, and budget for regular tank and pad care.

Sources

This assessment uses Dreame's U.S. X60 Ultra product page, its U.S. native model and variant record, the exact U.S. X60 Ultra manual, and the U.S. robot-vacuum collection row that contains this offer. Performance and capacity figures above are manufacturer statements with the limitations noted; no independent laboratory or ownership results are claimed.